Motor Voltage Controller

The P-MOVOC device is supplied as a necessary complement of the range of advanced frameless PM series TK motors when a constant power range in excess of 3:1, and up and beyond 1:10, is planned for the application. 

Motor Voltage Controller

Details
Movoc - Motor voltage controller

The special design and manufacturing technology of high speed TK motors allows a very wide constant power, flux controlled operating range which can exceed the ratio 10:1. This means that the motor back EMF is approximately equal to the drive maximum voltage (typically very close to the supply voltage) at the motor knee speed, i.e. at the lowest speed of the constant power range.

In normal operation, at higher speeds the drive feeds the motor, which is designed to display a calibrated, critical amount of impedance, with just the right amount of Id to keep the motor voltage constant throughout the constant power range.
This means that at the highest permissible speed the motor back EMF is higher than the supply voltage, intrinsically the back EMF is about equal to the supply voltage times the constant power range.
As a consequence, without a voltage controller device, if the drive were to stop supplying Id to the motor when operating in flux control mode, a high voltage would be fed to the motor terminals. The vantage controller is thus added to the motor circuit to prevent any such occurrence. 
The voltage controlled device is connected between drive and motor, enerally and preferably near the drive.
If, for any reason, the drive were to stop supplying Id to the motor while operating at high speed, the voltage controller would detect the voltage rise and trigger a crowbar short circuiting all motor terminals so that the voltage across the motor is nullified and the current in the device is the short circuit current of the motor.
In turn, the short circuit current of high speed motors is very close to the nominal motor current.
The motor would then idle down with high current but relatively little braking power. The motor voltage controller operates with or without power supply and only clears the motor short when the motor is completely stopped.
Variants

Electrical characteristics

Power terminals including ground protection

P_Movoc 40A   P_Movoc 80A   P_Movoc 200A  
Crowbar maximum current 60 A Crowbar maximum current 120 A Crowbar maximum current 250 A
Rated current 40 A Rated current 80 A Rated current 200 A
Thermal rating, crowbar current 20A >120 s Thermal rating, crowbar current 60A 115 s Thermal rating, crowbar current 150A >120 s
Thermal rating, crowbar current 30A 110 s Thermal rating, crowbar current 70A 75 s Thermal rating, crowbar current 175A 60 s
Thermal rating, crowbar current 40A 90 s Thermal rating, crowbar current 80A 45 s Thermal rating, crowbar current 200A 25 s
Thermal rating, crowbar current 50A 40 s Thermal rating, crowbar current 100A 20 s Thermal rating, crowbar current 225A 10 s
Thermal rating, crowbar current 60A 15 s Thermal rating, crowbar current 120A 10 s Thermal rating, crowbar current 250A 4 s

 

 

 

Search a file

Are you looking for a specific file or document? Use our download finder to find it faster

Contact us

Do you need more information about our products? Fill out the form below

This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply